TELL-TALE CRACK METER
Tell-Tales are precision gauges that consist of two plates which overlap for part of their length. The bottom plate is calibrated in millimetres and the top plate is transparent and marked with a hairline cursor in the form of a cross.
Description
Tell-Tales are precision gauges that consist of two plates which overlap for part of their length. The bottom plate is calibrated in millimetres and the top plate is transparent and marked with a hairline cursor in the form of a cross.
They are manufactured in vandal resistant polycarbonate. The coefficient of linear thermal expansion is 7.0 x 10-5cm/cm/ºC for ambient temperatures between -30ºC to +30ºC. They are manufactured to conform to BS EN ISO 9001:2015.
The Tell-Tale is fixed across the crack using screws and plugs and/or adhesive. It can be used across cracks in vertical or horizontal directions on flat surfaces.
The Tell-Tale is preset at zero with transparent tape. The tape is cut after the Tell-Tale is fixed across the crack.
As the crack opens, or closes, the cursor moves relative to the calibration scale. The opening or closing of the crack is then recorded on a crack record sheet.
Additional information
| Brands | |
|---|---|
| Standard Model Range |
± 20mm |
| Plus Model Range |
± 25mm |
| Corner Model Range |
± 25mm |
Reviews (0)
Related products
PRESSURE TRANSDUCER VWT-9000 SERIES
In stock
The Geosense® VWT-9000 Series of Pressure Transducers are designed to be connected directly into hydraulic or pneumatic pressure lines by means of a 1/4” BSPF thread. Other thread sizes are available on request.
They are typically used to monitor uplift pressures within dams and to enable manual standpipe piezometers to be upgraded into an automated data acquisition system.
IN-PLACE TILT METER MEMS
In stock
SUBMERSIBLE TILT METER
In stock
TILT BEAM
In stock
The Tilt Beam is a lightweight, rigid aluminium beam that is used in conjunction with a Triaxial Tilt Node, a NanoPlus or a NanoMacro.
The tilt beam has been successfully used in many applications, including:
- Movement monitoring of any structure
- Longitudinal settlement
- Tunnel convergence/divergence
- Lateral displacements
TILT BEAM MEMS
In stock
MEMS Tilt Beams are designed for attachment to structures, on either a vertical or horizontal surface, for the measurement of tilt or differential settlement.
They consist of a highly accurate MEMS sensor housed in a fully sealed enclosure which is mounted on a lightweight rigid GRP beam. This can be mounted onto the structure using special anchors. The GRP beam has a very low coefficient of thermal expansion meaning that thermal affects are minimised.
WATER LEVEL METER
In stock
PENDULUM SYSTEM
In stock
HPS-3500 (Hanging) and IPS-3000 (Inverted) Pendulums are used to measure the tilt or rotation by measuring the relative internal horizontal displacement of points along a true vertical line. Each has a tensioned, stainless steel wire and the effects of the earth gravitational forces to guarantee a perfectly vertical line between a fixed point and a tensioning mechanism. Typical applications include concrete dams, bridges and high rise buildings.
INCLINOMETER CASING XC
In stock
Reviews
There are no reviews yet.