Load Cells
Showing all 6 results
Show
12
VW ANCHOR LOAD CELLS VWLC-5000
In stock
The VWLC 5000 series Vibrating Wire Anchor Load Cells consist of a cylinder of high strength steel with 3 to 6 vibrating wire strain sensors (depending on capacity) mounted parallel to the longitudinal axis arranged equidistant around the circumference which measure the compression of the cylinder under load.
They are manufactured with a Center hole to accommodate anchors, rock bolts and tendons.
HYDRAULIC ANCHOR LOAD CELL HLC-6000
In stock
The Geosense® HLC-6000 series Hydraulic Anchor Load Cells consist of a sensitive pressure pad formed by joining two stiff steel discs at their periphery. The void inside the cell is filled with de-aired fluid. When load is applied to the cell the pressure of the inside liquid changes. The changes in pressure correspond directly to the load applied.
Manufactured with a center hole to accommodate anchors, rock bolts and tendons.
STRAIN GAUGE ANCHOR LOAD CELLS SGLC-7000
In stock
The SGLC 7000 series load cell consists of a cylinder of high strength steel with a series of electrical resistance strain gauges connected around the periphery as a Wheatstone Bridge that compensates for unevenly distributed loads and provides a single mV/V signal output.
They are manufactured with a center hole to accommodate anchors, rock bolts and tendons.
VW LOAD CELL VWLC-5050
In stock
LOAD CELL FOR TUNNEL LININGS AND STRUTS
In stock
This type of load cell is used to monitor stresses in steel linings, struts, piles and support beams.
It consists of a sensitive pressure pad formed by joining two stiff steel discs at their periphery. The void inside the cell is filled with de-aired fluid. When load is applied to the cell the pressure of the inside liquid changes. The changes in pressure correspond directly to the load applied.
The pressure in the loads cell is measured by a resistance transducer.
STRAIN GAUGE LOAD CELL SGLC-7050
In stock
For measuring loads in rock bolts, strand anchors and struts.
