Geosense
Showing 19–27 of 58 resultsSorted by latest
Show
12
HYDRAULIC ANCHOR LOAD CELL HLC-6000
In stock
The Geosense® HLC-6000 series Hydraulic Anchor Load Cells consist of a sensitive pressure pad formed by joining two stiff steel discs at their periphery. The void inside the cell is filled with de-aired fluid. When load is applied to the cell the pressure of the inside liquid changes. The changes in pressure correspond directly to the load applied.
Manufactured with a center hole to accommodate anchors, rock bolts and tendons.
VW HYDROSTATIC PROFILER
In stock
BOREHOLE ROD EXTENSOMETER
In stock
The Geosense® GEO-XB2 borehole rod type extensometer range is used to measure and locate settlement, displacement and deformation in soil and rock.
It consists of a reference head and one or more in-hole anchors each of which is placed at a known depth and connected to the reference head by either a rigid or flexible rod running inside a flexible sleeve, which keeps the rod de-bonded from the grout.
MULTI-POINT VW PIEZOMETER
In stock
STRAIN GAUGE ANCHOR LOAD CELLS SGLC-7000
In stock
The SGLC 7000 series load cell consists of a cylinder of high strength steel with a series of electrical resistance strain gauges connected around the periphery as a Wheatstone Bridge that compensates for unevenly distributed loads and provides a single mV/V signal output.
They are manufactured with a center hole to accommodate anchors, rock bolts and tendons.
VW LOAD CELL VWLC-5050
In stock
PUSH-IN PRESSURE CELL
In stock
A Push-in Pressure Cell, also called Spade Cell, is designed to be pushed into the ground where it can measure total earth pressure and pore water pressure within the soil. It can be used as a site investigation tool to determine the in-situ stress state, both vertical and horizontal, depending on the direction of installation. In addition, it can be used to monitor the change in active and passive pressure around retaining structures (diaphragm walls etc) as well as in tunnelling, and other earthworks. Typical installations are in fine grained cohesive soils, including very soft to stiff clays.
LOAD CELL FOR TUNNEL LININGS AND STRUTS
In stock
This type of load cell is used to monitor stresses in steel linings, struts, piles and support beams.
It consists of a sensitive pressure pad formed by joining two stiff steel discs at their periphery. The void inside the cell is filled with de-aired fluid. When load is applied to the cell the pressure of the inside liquid changes. The changes in pressure correspond directly to the load applied.
The pressure in the loads cell is measured by a resistance transducer.
STRAIN GAUGE LOAD CELL SGLC-7050
In stock
