EXTENSOMETER GEO-XW100
The GEO-XW100 Rotary Wire Extensometer is designed to monitor the changes in distance between two anchor points up to a maximum of 30 meters apart.
It comprises a rotary potentiometric displacement gauge, an opposing anchor and a stainless steel wire that runs between the displacement gauge and the opposing anchor. With a wire extension kit, the length of the wire can be extended up to a maximum distance of 30 meters.
The displacement gauge is housed within a rugged steel enclosure with a mounting plate for horizontal or vertical mounting.
Two options for installation are available as follows:
- Exposed wire in combination with expansion anchor and eyebolt typically for attaching to rock or concrete.
- Wire running within a protective sleeve where the bottom anchor is mounted in the bottom cap at the end of the protective sleeve. The protective sleeves can either be mounted on posts above ground or buried typically used for slope and/or landslide monitoring.
| Brands | Geosense |
|---|---|
| Sensor type | Potentiometric linear transducer |
| Displacement range | 1800mm to 8300mm (model dependent) |
| Accuracy | ± 1mm (dependent on temperature) |
| Resolution | Infinite |
| Non linearity | ± 0.25% FS (1800mm to 4300mm); ± 0.5% FS (4800mm to 8300mm) |
| Repeatability | ± 0.03mm |
| Output signal | 4-20mA |
| Power supply | 12-30 VDC |
Related products
VW PIEZOMETER VWP-3000 SERIES
In stock
VWPHT-3600 SERIES
In stock
The VWPHT-3600 series High Temperature Piezometers are suitable for the extreme environments of temperature and pressure found within applications such as geothermal heat and enhanced oil recovery systems including steam assisted gravity drainage (SAGD) and cyclic steam stimulation (CSS). They are capable of monitoring high temperatures up to 250°C and pressures up to 34.5 MPa.
PRESSURE TRANSDUCER VWT-9000 SERIES
In stock
The Geosense® VWT-9000 Series of Pressure Transducers are designed to be connected directly into hydraulic or pneumatic pressure lines by means of a 1/4” BSPF thread. Other thread sizes are available on request.
They are typically used to monitor uplift pressures within dams and to enable manual standpipe piezometers to be upgraded into an automated data acquisition system.
OPTICAL DISPLACEMENT SENSOR NODE
In stock
TRIAXIAL TILT SENSOR NODE
In stock
SUBMERSIBLE TILT METER
In stock
INCLINOMETER CASING QJ
In stock
HUMIDITY & CORROSION (CorroDec®2G)
In stock
The structural infrastructure must always meet requirements such as performance, stability and durability. These requirements will have a lasting effect on our mobility in the future. The corrosion risk and the corrosion activity of the reinforcing steel largely define these requirements and are determined by various impact and material parameters.

Reviews
There are no reviews yet.