Crack Sensor Node
The Crack Sensor Node is used to monitor structural movement including pile separation, crack movement and expansion joint movement.
The Crack Sensor Node interfaces to a linear displacement sensor. It’s high precision sampling circuit powers the sensor and reports its measurements through Senceive’s wireless communications network to a Gateway. It has been successfully used in many applications, including those measuring:
- Crack movement
- Pile separation
- Structural movement
- Expansion joint monitoring
Description
Features
- Waterproof, robust connectors for simple installation
- Automatic sensor type detection
- Extremely low noise performance
- 16-bit resolution (65,536 steps over the full scale)
- Integrated long life battery
- 12-15 years’ battery life
- Internal temperature sensor
- One and two channel variants offered as standard
- Waterproof to IP66 / IP67 / IP68
- Variety of fixings available for easy installation on site
Additional information
| Brands | |
|---|---|
| Circuit Topology |
Voltage divider |
| Stimulus |
2.5V, 100mA max |
| Resolution |
0.0015% of full scale |
| Noise Level |
0.005% of full scale (typical peak to peak) |
Reviews (0)
About brand
Since 2005, Senceive has been singularly focused on bringing intelligent wireless condition monitoring to civil engineering and rail applications. Senceive is widely seen as the global leader for wireless remote condition monitoring solutions, with more than 30,000 sensors installed in 2020 alone.
Related products
VW PIEZOMETER VWP-3000 SERIES
In stock
VWPHT-3600 SERIES
In stock
The VWPHT-3600 series High Temperature Piezometers are suitable for the extreme environments of temperature and pressure found within applications such as geothermal heat and enhanced oil recovery systems including steam assisted gravity drainage (SAGD) and cyclic steam stimulation (CSS). They are capable of monitoring high temperatures up to 250°C and pressures up to 34.5 MPa.
PRESSURE TRANSDUCER VWT-9000 SERIES
In stock
The Geosense® VWT-9000 Series of Pressure Transducers are designed to be connected directly into hydraulic or pneumatic pressure lines by means of a 1/4” BSPF thread. Other thread sizes are available on request.
They are typically used to monitor uplift pressures within dams and to enable manual standpipe piezometers to be upgraded into an automated data acquisition system.
NANO TRIAXIAL TILT SENSOR
In stock
The Nano range uses the same core platform as our other tilt sensors, so it can deliver a similar level of performance and reliability, all in a small and robust enclosure. Nanos have been successfully used in many applications, including:
- Tunnel distortion
- Tunnel heave/settlement
- Embankment slippage (used in conjunction with stake mounts)
- Structural movement
- Rail track heave/settlement
- Rail trackbed cant and twist
TRIAXIAL TILT SENSOR NODE
In stock
PORTABLE MEMS INCLINOMETER
In stock
The MEMS Portable Inclinometer system utilises modern communication and Smart devices to enable the tilt data generated by the probe to be managed, stored and transferred directly from site via FTP, API, email or other communication platforms.
It is available for vertical, inclined and horizontal applications.
HUMIDITY & CORROSION (CorroDec®2G)
In stock
The structural infrastructure must always meet requirements such as performance, stability and durability. These requirements will have a lasting effect on our mobility in the future. The corrosion risk and the corrosion activity of the reinforcing steel largely define these requirements and are determined by various impact and material parameters.
INCLINOMETER SPIRAL SENSOR
In stock
Reviews
There are no reviews yet.