FlatMesh 4G Gateway
The FlatMesh 4G Gateway is a fully integrated unit which provides all the functionality required to operate a FlatMesh network in a remote location.
No fixed IP address is required for the cellular service; the Gateway simply initiates the connection with Senceive WebMonitor software over the internet.
- Integrated Twelve Band LTE, Seven Band UMTS/HSPA+ and Quad Band GSM/GPRS/EDGE Modem for worldwide use
- Integrated solar charging circuit connected to internal lithium-ion rechargeable battery pack (no external battery pack)
- Fully operational, including FlatMesh and cellular radios, for up to three weeks on internal battery
- On-board industrial-grade flash memory card for data buffering and backup
- Incorporates bracket for mounting to pole or wall
- Waterproof connection to solar panel or other DC power supply
- All components waterproof to IP67
- Firmware is remotely upgradeable over the air reducing costly site visits
- Extended temperature range battery option available for extreme conditions
- Micro-USB connector for maintenance and local data access
| Brands | Senceive |
|---|---|
| Housing Material | Die cast aluminium body ASA polymer lid rated to UL94HB Die cast aluminium lid optional |
| International Protection Marking | IP67 |
| Mounting Options | Combination wall / pole mount bracket included Low profile pole clamp available as an option |
Related products
MULTI-POINT VW PIEZOMETER
In stock
VWPHT-3600 SERIES
In stock
The VWPHT-3600 series High Temperature Piezometers are suitable for the extreme environments of temperature and pressure found within applications such as geothermal heat and enhanced oil recovery systems including steam assisted gravity drainage (SAGD) and cyclic steam stimulation (CSS). They are capable of monitoring high temperatures up to 250°C and pressures up to 34.5 MPa.
DRIVE-IN PIEZOMETERS WP-3400 & SGP-3500 SERIES
In stock
Drive-in piezometers, also referred to as push-in piezometers, are designed for installing in soft clays, organic or fine grained cohesionless soils typically with a SPT-N value less than 10. They are available with a CPT fitting or 1” BSP thread.
Depending on the depth and type of soil, they can either be pushed directly into the soil from ground level to the required depth or pushed into the base of a CPT test or drilled borehole.
TILT BEAM
In stock
The Tilt Beam is a lightweight, rigid aluminium beam that is used in conjunction with a Triaxial Tilt Node, a NanoPlus or a NanoMacro.
The tilt beam has been successfully used in many applications, including:
- Movement monitoring of any structure
- Longitudinal settlement
- Tunnel convergence/divergence
- Lateral displacements
DIGITAL PIEZOMETER – dPiezo
In stock
TILT BEAM MEMS
In stock
MEMS Tilt Beams are designed for attachment to structures, on either a vertical or horizontal surface, for the measurement of tilt or differential settlement.
They consist of a highly accurate MEMS sensor housed in a fully sealed enclosure which is mounted on a lightweight rigid GRP beam. This can be mounted onto the structure using special anchors. The GRP beam has a very low coefficient of thermal expansion meaning that thermal affects are minimised.
INCLINOMETER CASING QJ
In stock
MAGNETIC EXTENSOMETER GXM RANGE
In stock
The GEO-XM settlement system is a magnet extensometer system used typically to monitor settlement and heave in foundations, excavations and embankments.
Data received identifies the depth and position where settlement has occurred as well as the total amount of settlement.
It can also be installed behind retaining structures, such as sheet piles and slurry walls, and above underground openings, such as tunnels and shafts.

Reviews
There are no reviews yet.