VW Comm Interface Module
Three industry standard communication interfaces are included: RS-232, RS-485 and SDI-12. The RS-232 interface provides compatibility with a wide range of standard wireless adaptors and modems including those from Digi International and Freewave, facilitating the deployment of cost-effective networks of wireless sensors.
The RS-485 interface allows an inexpensive, reliable wired network to be built using simple twisted pair cabling. Up to 61 nodes are supported in a wired network, with up to 1200m (4000’) of cabling. The network can be easily extended with RS-485 repeaters.
The vibrating wire interface consists of a precision differential amplifier with band-pass filtering, which improves noise rejection and measurement reliability. The excitation and measurement parameters are programmable to support all commonly used vibrating wire instruments. Reading output can be programmed for digits (Hz^2×10–³), frequency (Hz) or period (μS).
The VW Comm Module also includes support for reading YSI44005 type thermistors to provide sensor temperature measurements. Other thermistors or temperature devices are supported as well.
In addition to the vibrating wire and thermistor input capability, a single-ended voltage up to 2.5 VDC can be measured. A high accuracy 2.5 VDC reference is also provided for powering other sensors such as RTD’s and linear potentiometers. 10-bit measurement resolution can be improved with configurable averaging. The voltage input range can be offset from 0.5 to 2.5 VDC to optimize the resolution for 4-20 mA sensors. The VW Comm can also read the power supply voltage and internal temperature.
| Brands | Canary Systems |
|---|
Related products
STRAIN GAUGE PIEZOMETER SGP-3400 SERIES
In stock
The SGP-3400 Series of strain gauge piezometers are designed for monitoring soil pore pressure or changes in water level and are also suitable for dynamic monitoring such as pumping tests.
They are accurate, highly-reliable and suitable for use in the harsh environments often found within civil engineering including water wells, boreholes, dams, reservoirs, rivers, tanks or any other body of water.
DRIVE-IN PIEZOMETERS WP-3400 & SGP-3500 SERIES
In stock
Drive-in piezometers, also referred to as push-in piezometers, are designed for installing in soft clays, organic or fine grained cohesionless soils typically with a SPT-N value less than 10. They are available with a CPT fitting or 1” BSP thread.
Depending on the depth and type of soil, they can either be pushed directly into the soil from ground level to the required depth or pushed into the base of a CPT test or drilled borehole.
PORTABLE MEMS INCLINOMETER
In stock
The MEMS Portable Inclinometer system utilises modern communication and Smart devices to enable the tilt data generated by the probe to be managed, stored and transferred directly from site via FTP, API, email or other communication platforms.
It is available for vertical, inclined and horizontal applications.
IN-PLACE INCLINOMETER (IPI)
In stock
DIGITAL PIEZOMETER – dPiezo
In stock
STANDPIPE PIEZOMETER
In stock
TILT BEAM MEMS
In stock
MEMS Tilt Beams are designed for attachment to structures, on either a vertical or horizontal surface, for the measurement of tilt or differential settlement.
They consist of a highly accurate MEMS sensor housed in a fully sealed enclosure which is mounted on a lightweight rigid GRP beam. This can be mounted onto the structure using special anchors. The GRP beam has a very low coefficient of thermal expansion meaning that thermal affects are minimised.
WATER LEVEL METER
In stock

Reviews
There are no reviews yet.